Call Us: 
We were asked to make a canopy for a fire in a local public house. We went along to measure up and also to do a smoke test to make sure there was enough pull on the chimney. The pub had a gas fire before, so we organised for a gas safe engineer to come along to disconnect the fire. We went back to the workshop to start making the canopy. We designed the canopy on a computer, then transferred it to our CNC plasma cutter to profile the parts. We bent the parts and welded it together, then riveted … [Read more...]
Category : installations
AGA Wenlock stove
March 7, 2013 by
After doing a survey on this job we recommended fitting a 904 stainless steel liner. The client accepted our quote so we proceeded. We noticed that the stove would be a tight fit in the opening, so we decided to make a offset pipe to connect the stove to the stainless steel liner. We made the offset pipe and the register plate at our workshop, using our CNC plasma machine to cut out the pipe. Next we rolled the metal into a pipe and welded the three bits of pipe together. Once the liner was … [Read more...]
Stovax Stockton 5
February 26, 2013 by
We installed a wood burning stove in Westoning just before christmas. This involved knocking out the opening to have enough clearance around the stove for a air gap. We made a register plate which was fitted, then a slate hearth was installed. We then rendered the back and sides, then measured up to make a sheet metal frame to go around the opening. The frame was painted black to match the stove. … [Read more...]
Clearview 400
February 26, 2013 by
We recently finished installing a clearview 400 stove into a house in St Albans. We had to knock out the fire place to make room for this stove to fit. After we had knocked out the opening to the right size, we fitted the hearth. Once this had dried we fitted a register plate with a soot door. Once this was done we made good by rendering the back and sides, and re-plastering the front wall to make it look nice again. A good job done. … [Read more...]